Difference between revisions of "Laser Cutter Settings"

From Twin Cities Maker wiki
Jump to: navigation, search
(leather; wood notes)
(1/2" poplar)
Line 14: Line 14:
 
| 100 pwr/40 spd
 
| 100 pwr/40 spd
 
| Lower the speed for a deeper etch. Use orange cleaner to get rid of the sticky sap residue left behind.
 
| Lower the speed for a deeper etch. Use orange cleaner to get rid of the sticky sap residue left behind.
 +
|-
 +
| Poplar, 1/2"
 +
| 25 pwr/100 spd
 +
| 100 pwr/30 spd
 +
| <br/>
 
|-
 
|-
 
| Acrylic, 1/8"
 
| Acrylic, 1/8"

Revision as of 20:26, 25 September 2013

 

Pages relating to
the Full Spectrum laser cutter
Laser Cutter
Laser Cutter Materials
Laser Cutter Settings
Software Tips
Authorized users

Recommended settings for a variety of materials. Please add to this list!

Material Etch Settings Cut Settings Notes
Poplar, 1/4" 25 pwr/100 speed 100 pwr/40 spd Lower the speed for a deeper etch. Use orange cleaner to get rid of the sticky sap residue left behind.
Poplar, 1/2" 25 pwr/100 spd 100 pwr/30 spd
Acrylic, 1/8" 2 - 8 pwr/100 spd 8 pwr/15 spd
Drawing paper
0.2 pwr/100 spd
Posterboard
0.5 pwr/100 spd
Transparency film
0.5 pwr/100 spd
Plywood, 1/4" 25 pwr/100 spd 40 pwr/100 spd Use orange cleaner to get rid of the sticky sap/glue residue left behind.
Ceramic tile 60 pwr/40 spd
Beware -- the laser spot is screaming bright!
Leather, ~1/8" 1-2 pwr/100 spd 20 pwr/70 spd As for tile, the laser spot is blinding. Stinky -- let the chamber clear for a couple of minutes before you open it. Cut edges will have an ashy residue.