uptownmaker wrote:I spent some time toying with this last night, just to see what I could do, and I found a few difficulties.
First, as I was afraid of, getting things parallel and square is a problem. Not a huge one, just...a problem. But that may well be at least partly due to my subpar woodworking skills and equipment- we'll see.
Second, there's a few parts we're going to need to make this go forward, if anyone would care to check their scrap heaps and junk boxes:
- threaded rod, ~2x 5' long, 1x 24"-29" long (can cut down)(I think I have this). Prefer no more than 20TPI, no larger than 3/8" diameter
- slide bearings, ~29.5" wide or less
- motor shaft coupler- this is a somewhat rare piece that may well need to be ordered
When should we schedule another work date?
uptownmaker wrote:If you try to drive from one side, that side will need to be improbably rigid to avoid torquing the gantry and introducing twist.
Drive needs to be symmetrical- either drive both sides (with two motors or with one motor and a mechanic linkage between the two) or use one drive which is centrally located.
A center drive screw is also a very possible solution to the problem- the gantry has a "box" around the frame, and the box rides on wheels above and below the side rail, with the cross bar underneath having the drive screw attached to it.
I will try to model it in SketchUp- it's a good excuse to work on my skills.
Users browsing this forum: No registered users and 0 guests