metis wrote:metal comes to mind, specifically aluminum angle, btu even if you've no expierence, sheet aluminum and self tapping screws or even pop rivets will probably do most of the burlyness you require.
metris wrote:traditionally for road cases you're gonna use baltic birch plywood, which is more robust for most things and gives the system a non-systemic failure (when it's over stressed part of it breaks instead of deforming as metal will, possibly damaging several components as it transfers stress) 3/8" is the typical thickness.
I'm kind of lumber-stupid, can I get 'baltic birch plywood' at Menards / Home Depot?
noise wrote:This sounds like a cool project, are you going to haul your synth over to Handmade Music to show it off?
Users browsing this forum: No registered users and 0 guests