The shopSmith Mark V that Scott has loaned on long term is in need of a single part to make the Bandsaw and Jointer both workable.
It is a piece of plastic that connects the two hubs together from the Motor.
It will run about $30 shipped http://www.shopsmith.com/ownersite/part ... 3574&qty=1
I cannot afford to buy it outright and still pay my dues, but I could dig up part of it if others wanted to chip in. Or else I could buy it as part of my dues, but until I start working again I get either Dues or toys to spend my monthly allotment of funds on.
Any body want this up and working?