Jet Table Saw

What things would you use at the maker shop?
User avatar
Odegard
Posts: 120
Joined: Thu May 12, 2011 3:46 pm
Location: South Minneapolis
Contact:

Jet Table Saw

Postby Odegard » Sun May 13, 2012 5:16 pm

Good news for users of the Jet table saw. It has been under the weather for a time, but I now have a replacement part in my hot little hands. It's my intent to install the new trunnion on Tuesday or Wednesday night this week. We can look forward to full function once again!

If you have not yet heard, this most-often-used tool was a welcome gift from John before he headed out to San Diego. Thanks John!


Sent from my iPod touch using Tapatalk
Christopher Odegard

User avatar
paulsobczak
Site Admin
Posts: 861
Joined: Sun Jan 11, 2009 6:35 pm
Contact:

Re: Jet Table Saw

Postby paulsobczak » Tue May 15, 2012 12:54 pm

Thanks John!

User avatar
Odegard
Posts: 120
Joined: Thu May 12, 2011 3:46 pm
Location: South Minneapolis
Contact:

Jet Table Saw

Postby Odegard » Wed May 16, 2012 6:22 pm

Disheartening news. The wrong part was ordered. I will be ordering the correct part, and will determine whether to also replace the part mistakenly ordered, depending on the condition of the original. Sorry gang.


Sent from my iPod touch using Tapatalk
Christopher Odegard


Return to “Uses/Equipment”

Who is online

Users browsing this forum: No registered users and 1 guest