I'm trying to learn how to use eagle because the fablab I have access to has a modela mini mill set up specifically to cut pcb's from eagle files into copper clad board. So I copied most of this schematic from the sanguino files and then laid out the board myself. It's single layer and I was very proud until I realized the board didn't update when I made a change to the schematic, so now there's no jumper for a 9v input.
Please take a look and tell me what could be better, or what you'd want on a board for the 644p's. I think 2 layers is a possibility, the board is just more expensive and I'll have to be really careful lining it up for the 2nd run. If anyone wants a few let me know, I'll be ordering some pieces of copper soon.
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum